High Voltage Tester Age
You need a high quality.
ANPS 9620USB PCB Repair Meter and Breaker.

If you are using a beeper with bottery(9V,350Ωsingle judgment), ofcourse
you can not test outcontinuity under 350Ω
and insulation upper than 350.
So, There must be used to happen mis judgment and have to retest, this always cost much and time. Evenmore, the customers may complain and return the goods. It not only the lost of the money but also the reputaion of the company.

ANPS-9620 Signature

High voltage test specification, using double judgment value. Operator could judge in time with viewing resisrance value on monitor when repairing. 300V high voltage test (the same with tester) after patching line, attach five levels accurate breaker. Simulate tester specification, let service department to measure the board which comeback by customer. Build up correct repair flow, solve quality test blind spot, increase outgoods quality.

ANPS-9620 Function

Design with high volatge tester specification, using double judgment value:
Continuity test with 8V/1Ω∼50Ω.
Insulation test with 250V∼300V/800KΩ∼200MΩ.
You could find every problem points which found by high voltage tester, and operaors will never judge wrong. Solve quality test blind spot, Save time and money for the company, assure outgoods quality.

ANPS-9620 Acurate breaker with changing power

If you are using 110V high power braker (70V/1A) with light bulb, there usally let high density board turn to black or break normal thin line. ANPS 9620usb offer 75V(1A/1.2A/1.5A/1.8A/2.0A) five levels power, you could change power according to PCB sorts. Avoid PCB turn to black or brake thin line. This high accurate breaker is made for future trend.

ANPS-9620 Solve microshort and microopen measurmen.

Used traditional beep meter will not beep when measured the resistance over 350Ω, and could not judge that is microshort or miss test. So the solution of problem boards is test again after high voltage break and repeat couple times, and could find real fail boards. Used traditional beep meter will always beep when the circuit resistance is below 350Ω and that is easily to consider the board was tested wrong. So the microopen boards should test repeatedly then we could find the fail boards. 9620usb repair meter and braker, short test specification is 250V∼300V/800KΩ∼200MΩ, operator only need judge the board is microshort or miss test by high voltage beep meter, and select microopen board to break by high voltage, then measure again. If that board is passed, test again by tester, otherwise judge the board as a fail board.

Conclusion

This product use double judgment mechanism that is the same as high voltage tester. The problem boards, that were tested by tester, could find problem point immediately. This can save time and cost on the testing and point finding by operator. All measurement problems will judge by machine and avoid the miss judgment by operatoror or the problems caused by his lack of experience. Combine three function(electric tester, power changeable braker, high voltage meter) in one machine, specially made for quality assurance, avoid all quality measurement problems, and let operator easy to solve the problems.